A Review on Productivity Improvement on CNC Lathe by Automatic Loading and Unloading of Bearing Component

Authors

  • Bharat Dodiya PG Scholar

DOI:

https://doi.org/10.37591/joeam.v9i1.481

Abstract

The present techno-economic scenario conventional lathes are replacing by computer numerical controlled machineries for mass production and quality work. For improve production rate, efficiency improvement, reduce machining cycle time, cost reduction ,material handling, eliminate waste and overcome the fatality of  labor during machining operation, manufacturer are including in computer numerical controlled machines ,solution of loading and unloading of components on machine with automation instant of  manually loading and unloading to reduce operator fatigue and increase efficiency. Automation in loading and unloading is one of the most critical and difficult task, as it has depends on numbers of independent variables and parameters. By analysis of current scenario of loading and unloading system and eliminating undesirable moment of component, improvement in production rate is achieved.

Author Biography

  • Bharat Dodiya, PG Scholar

    Atmiya Institute of Technology and Science, Rajkot. Affiliated to Gujarat Technological University, India

Downloads

Published

2018-06-12

Issue

Vol. 9 No. 1 (2018)

Section

Research Article

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.