Sinusoidal Pulse Width Modulation Switching Technique based Single Phase Inverter

Authors

  • Jaydipsinh Zala Professor, Department of Electrical Engineering, Dr. Subhash Technical Campus, Junagadh, Gujarat, India
  • Manan Desai Professor, Department of Electrical Engineering, Dr. Subhash Technical Campus, Junagadh, Gujarat, India
  • Kishan Bhayani Professor, Department of Electrical Engineering, Vyavsayi Vidya Pratishthan Engineering College, Rajkot, Gujarat, India
  • Anoop Budhvani Professor, Department of Electrical Engineering, Vyavsayi Vidya Pratishthan Engineering College, Rajkot, Gujarat, India

DOI:

https://doi.org/10.37591/.v9i1.1531

Abstract

This paper discusses about the inverter which transfers power from DC source to AC load side. Inverters are usually used in motor drive, static var compensators, uninterruptible power supplies (ups), etc. Pulse Width Modulation (PWM) technique is used because the total harmonics distortion is low as compared with other techniques. The switching scheme of sinusoidal PWM permits control of the frequency and the magnitude of the output. This switching scheme gives output with harmonics in range of the switching frequency and higher range which can be easily removed by proper filter design. This paper suggests half-bridge and full-bridge SPWM inverter with unipolar and bipolar switching schemes which can minimize the total harmonics distortion and enhance the output voltage.


Keywords: Sinusoidal Pulse Width Modulation (SPWM), unipolar, bipolar, Total Harmonics Distortion (THD), Pulse Width Modulation (PWM)

Cite this Article

Jaydipsinh Zala, Manan Desai, Kishan Bhayani, et al. Sinusoidal Pulse Width Modulation Switching Technique based Single Phase Inverter. Journal of Power Electronics & Power Systems. 2019; 9(1): 15–21p.

Published

2019-02-28

Issue

Section

Research Article