Power Control of Doubly Fed Induction Generator (DFIG) Based on IP Controller

Authors

  • Mohammad Abdul Mannan Department of Electrical and Electronics Engineering, Faculty of Engineering, American International University Bangladesh (AIUB), Dhaka, Bangladesh Department of Electrical and Electronics Engineering, Kitami Institute of Technology, 165 Koen-cho, Kitami, Hokkaido, 090-8507 Japan
  • A.K.M Rejwanul Haque
  • Junji Tamura

DOI:

https://doi.org/10.37591/.v6i3.3198

Abstract

Conventionally, the indirect power control of Doubly Fed Induction Generator (DFIG) has been developed based on conventional Proportional-Plus-Integral (PI) controller due to its simple construction and implementation. The steady-state error minimization, overshoot elimination and disturbance rejection are not possible where the gains of PI controller are chosen by trial and error method. The steady-state error and disturbance rejection can be possible if the gains of PI controller are chosen by proper choosing of poles. But the overshoot elimination is not possible where PI based control is designed. In this paper, Integral-Plus-Proportional (IP) controller is proposed to design for power control of the DFIG. The IP controller is well suited to minimized the overshoot problem which is arisen in PI controller. The performance of proposed IP controller for power control of the DFIG system is analyzed and investigated through the simulation work. The results of simulation works are presented to demonstrate the effectiveness of propose IP controller compared with conventional PI controller. The proposed IP controller shows the superior performance over PI controller in terms of minimization of overshoot.

 

Keywords: Stator flux orientation control, Active and reactive power control, PI controller, IP controller, Doubly fed induction generator

Downloads

Published

2019-08-17

Issue

Vol. 6 No. 3 (2016)

Section

Research Article

License

Journal Title:

Title of the Paper:

Corresponding Author’s Information:

Name: Address:

E-mail:

Contact Number:

It is herein agreed that: The copyright to the above-listed unpublished and original article is transferred to STM Journals.

This copyright transfer covers the exclusive right to reproduce and distribute the contribution, including reprints, translations, photographic reproductions, microform, electronic form (offline, online), or any other reproductions of similar nature.

I/We declare that above manuscript is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

 I/ We warrant(s) that his/her/their contribution is original, except for such excerpts from copyrighted works as may be included with the permission of the copyright holder and author thereof, that it contains no libelous statements, and does not infringe on any copyright, trademark, patent, statutory right, or propriety right of others.

I/We will not publish his/her/their above said contribution anywhere else without the prior written permission of the publisher unless it has been changed substantially. I/We also agree to the authorship of the article in the following order: Author(s) Name Signature(s)

1. ________________

2. ________________

3. ________________

4. ________________

The author(s) agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal (comments if any to the editor can be added below).