Mechanical Properties of Hybrid Elastomer Blends

Authors

  • Ali I. Al-Mosawi University of Miskolc, Hungary
  • Mohammed H. Al-Maamori University of Babylon, Babylon, Hilla, Iraq
  • Shaymaa Abbas Abdulsada University of Miskolc, Hungary

DOI:

https://doi.org/10.37591/jotcsta.v4i1.2391

Keywords:

NBR/CR, Novolac nano additives, mechanical properties, hybrid blends

Abstract

Novolac nano additives (0–40) wt.% were added to NBR/CR hybrid blends and study the influence on mechanical properties of rubber. Mechanical properties included: hardness, resilience, and Compressibility. The results obtained from IRHD test, hardness test and compression test shown that the novolac nano additives has a positive effect on the hardness of hybrid rubber, where the hybrid rubber hardness increases with increasing the amount of novolac nano additive. In the case of compressive strength and resiliency, the situation is quite the opposite, where we observe dropping the value of these properties after adding novolac nano additive.

Author Biographies

Ali I. Al-Mosawi, University of Miskolc, Hungary

Department of Polymer, Faculty of Materials Science and Engineering

Mohammed H. Al-Maamori, University of Babylon, Babylon, Hilla, Iraq

Department of Polymer, College of Materials Engineering

Shaymaa Abbas Abdulsada, University of Miskolc, Hungary

Department of Metallurgy, Faculty of Materials Science and Engineering

Downloads

Published

2019-04-19

Issue

Vol. 4 No. 1 (2017)

Section

Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.