Simulation of Single Phase AC-DC Power Factor Corrected Converter: A Technological Review
DOI:
https://doi.org/10.37591/.v6i1.3105Abstract
This paper is intended to review the significant development of power factor correction by using boost converter topology for single phase power supply to the load in the last decay. Contents in this review paper starts with an introduction of power factor correction by boost converter topology adopted by many industries. Different power factor correction methods are available, which can be applied to get better power factor and low harmonic and get better power quality supply with high efficiency and low losses, are also discussed. Hysteresis control and average control both techniques are very efficient for the power factor correction. These techniques are a part of the current mode control technique in continuous conduction mode. This design consists of modification in simple and low cost so that it is easy to implement in any circuit. The simulation results of both the techniques are compared and simulatory design for prototype 100 W power output is also discussed.
Keywords: PFC boost, hysteresis control, continuous conduction mode, average control, power quality, converter
Downloads
Published
Issue
Section
License
Journal Title:
Title of the Paper:
Corresponding Author’s Information:
Name: Address:
E-mail:
Contact Number:
It is herein agreed that: The copyright to the above-listed unpublished and original article is transferred to STM Journals.
This copyright transfer covers the exclusive right to reproduce and distribute the contribution, including reprints, translations, photographic reproductions, microform, electronic form (offline, online), or any other reproductions of similar nature.
I/We declare that above manuscript is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.
I/ We warrant(s) that his/her/their contribution is original, except for such excerpts from copyrighted works as may be included with the permission of the copyright holder and author thereof, that it contains no libelous statements, and does not infringe on any copyright, trademark, patent, statutory right, or propriety right of others.
I/We will not publish his/her/their above said contribution anywhere else without the prior written permission of the publisher unless it has been changed substantially. I/We also agree to the authorship of the article in the following order: Author(s) Name Signature(s)
1. ________________
2. ________________
3. ________________
4. ________________
The author(s) agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal (comments if any to the editor can be added below).
