Open Access
Subscription or Fee Access
Fabrication of Automatic Electromagnetic Braking System
Abstract
This paper is intended to showcase the modern emerging as well as efficient type of brakes i.e., automatic electromagnetic brakes. The principle used to fabricate these kinds of brakes is electromagnetic induction. It is intended to calculate brake torque & brake power & enhance it from previous values. Introduction of an
IOT system to electromagnetic braking system. Study & benefits over other brakes is discussed. Material selection for disc is analyzed. Scope is studied. Feasibility of EM Brakes is discussed. Selection of motor is also explained.
Keywords
References
N.B. Totala, P. Bhosle, S. Jarhad, S. Jadhav, and K. Kuchekar, “Electromagnetic Braking System,” In National Conference on Innovations in Mechanical Engineering, 6(8) (2015).
P. Dandavate, “An empirical review of electromagnetic braking systems,” International Journal of Research in Engineering and Science, 4(12) 15-23 (2016).
Yadav, A.K., Khan O., Khan, M.E., Utilization of High FFA Landfill Waste (Leachates) as a Feedstock for Sustainable Biodiesel Production: Its
Characterization and Engine Performance Evaluation, Environmental Science and Pollution Research, 25 (32), 32312-32320
Khan, T.A., Khan T.A., Yadav, A.K. A hydrodynamic cavitation-assisted system for optimization of biodiesel production from green microalgae oil using a genetic algorithm and response surface methodology approach, Environmental Science and Pollution Research, doi.org/10.1007/s11356-022-20474-w2022 , 2022
Yadav, A.K. , Khan, M.E., Pal A., Biodiesel Production from Oleander (Thevetia Peruviana) Oil and Its Performance Testing on a Diesel Engine,
Korean J. Chem. Eng., 2017; 34(2):340-345
Yadav A.K., Dewangan A., & Mallick A., Effect of n-Butanol and Diethyl Ether Additives on Performance and Emission Characteristics of a Diesel Engine Fuelled with Diesel-Pongamia Biodiesel Blends. Journal of Energy Engineering, (2018), 144(6), 04018062 (Publisher–ASCE-ASME; SCI Indexed)
Yadav A.K., Dewangan A., & Mallick A., Synthesis and Stability Study of Biodiesel from Kachnar Seed Oil, Journal of Energy Engineering. (2018), 144 (5), 04018053
Yadav, A.K., Khan, M.E., Pal A., Ultrasonic Assisted Production of Biodiesel from Karabi Oil using Heterogeneous Catalyst, Biofuels, 2018:9;101–112
Yadav, A.K., Vinay, Singh, B., Optimization of Biodiesel Production from Annona Squamosa Seeds
Oil Using Response Surface Methodology and Its Characterization" Energy Sources, Part A. 2018; 40(9) 1051-1059
Yadav A.K., Khan T.A., Khan T.A., and Kumar S., Methyl ester of Gmelina arborea oil as a substitute for petroleum diesel: an experimental study on its performance and emissions in a diesel engine, Energy
Sources, Part A, doi:10.1080/15567036.2019.1636164
Yadav, A.K., Khan, M.E., Pal A., Custard Apple Seed (Annona Squamosa) Oil as a Promising Feedstock for Biodiesel Production using Advanced Techniques and Its Experimental Investigations on an Agricultural Diesel Engine., Int. J. of Oil, Gas and Coal Tech., 2019: 20(4) 473-492
Khan O., Yadav, A.K., Khan, M.E., Sharma, D., The Ultrasonic Assisted Optimization of Biodiesel Production from Eucalyptus Oil, Energy Sources,
Part A: Recovery, Utilization, and Environmental Effects, 2017: 39:1556-7036
Dewangan A., Yadav A. K., Wax Deposition during Production of Waxy Crude Oil and Its Remediation, Petroleum science and technology, 2017;
(18):1831-1838
Dewangan, A., Yadav A.K., & Mallick A., Current Scenario of Biodiesel Development in India: Prospects and Challenges, Energy Sources, Part A.2018: 40(20):2494-2501
Dewangan A., Yadav A.K. & Mallick A., Optimization of Biodiesel Production and Engine Performance from Underutilized Simarouba Oil in
Compression Ignition Engine, Int. J. Oil, Gas and Coal Tech., 2020: 25(3) 357
Khan ,I. A., Singh S. K., Yadav A. K., Efficient Production of Biodiesel from Cannabis Sativa oil using Intensified Transesterification (Hydrodynamic Cavitation) Method, Energy Sources,
Part A, DOI: 10.1080/15567036.2019.1607946
Dewangan, A., Mallick, A., Yadav, A. K., Comparative study of Manilkara Zapota and Karanja
based Biodiesel Properties and Its Effect on Multi- Cylinder Diesel Engine Characteristics. Energy Sources, Part A, DOI.10.1080/15567036.2019.1661551
Singh, S., Singh, B., Kumar, S., and Yadav, A.K., Temperature-dependent dynamic hysteresis scaling of ferroelectric hysteresis parameters of lead free [(Ba 0.825 + xCa0.175-x) (Ti1- x Snx)O3]ceramics, Ferroelectrics, 2019, Vol. 551, 133–142
Ahmed A., Yadav, A. K., Singh A., Optimization of Biogas Yield from Anaerobic Co-digestion of Dualwaste for environmental sustainability: ANN, RSM, and GA, Approach., Int. J. of Oil, Gas and Coal Tech., (accepted; 2022)
Khan, O., Yadav, A. K., Khan, M.E., Characterization of Bio-Ethanol Obtained from Eichhornia Crassipes Plant; Its Emission and Performance Analysis on CI Engine. Energy Sources, Part A, DOI:10.1080/15567036.2019.1648600
Vinay, Singh B., Yadav, A. K., Optimization of Performance and Emission Characteristics of CI Engine Fuelled with Mahua Oil Methyl Ester-Diesel Blend using Response Surface Methodology, Int. J. of Ambient Energy (2020) 674-85 44(6)
Khan, I. A., Singh S. K., Yadav A. K., & Sharma D., Enhancement in the Performance of a Diesel Engine Fueled with Pongamia Methyl Ester and n-Butanol as Oxygenated Additive, Int. J. of Ambient Energy,
, 40(8), 842–846
Yadav, A. K., Singh, S., Gupta, G. Ghosh, U., Generation of Electricity through Staircase. Advance Science Letter , 2014;20: 1303–1306
Yadav, A.K., Khan, M.E., Pal A., Sharma D., Optimization of biodiesel production from bitter groundnut oil using Taguchi method and its
performance and emissions characteristics on a 4-cylinder Tata Indica engine. Int. J. Sust. Agri. Mgt. and Informatics, (2015), 1, .285–300
Yadav, A. K., Khan, M.E., Pal A., A Comparative Study on Ultrasonic Cavitation and Mechanical Stirring Method towards Efficient Production of
Biodiesel from Non-Edible Oils and Performance Testing on a C.I. Engine, Int. J. of Envt. & Waste Managt., 2016;18:349–367.
Yadav, A.K., Khan, M.E., Pal A., Performance and Emission Characteristics of a Stationary Diesel Engine fuelled by Schleichera Oleosa oil Methyl Ester (SOME) Produced through Hydrodynamic Cavitation Process, Egypt. J. of Petroleum, (2018): 27; 89–93
Yadav, A.K., Khan, M.E., Pal A., Kaner biodiesel production through hybrid reactor and its performance testing on a CI engine at different
compression ratios. Egypt. J. of Petroleum, 2017; 26, 525–532
Khan T.A, Yadav, A. K., Khan, M.E., Experimental Studies on Utilization of Neochloris Oleoabundans Microalgae Biodiesel as an Alternative Fuel for Diesel Engine, , Int. J. of Ambient energy, doi;10.1080/01430750.2022.2120909
Ahmed A., Yadav, A. K., Singh A., Biodiesel yield optimization from a third-generation feedstock (microalgae spirulina) using a hybrid statistical
approach. Doi: 10.1080/01430750.2023.2169758. , Int. J. of Ambient Energy, 2023.
Dewangan, A., Mallick, A., Yadav, A. K., Effect of Metal Oxide Nanoparticles and Engine Parameters on the Performance of a Diesel Engine: A Review, Materials Today: Proceedings, 2020;21; 1722-27
Dewangan, A., Mallick, A., Yadav, A. K., Combustion-Generated Pollutions in CI Engine and Strategy for Its Control: A Review, Materials Today: Proceedings 2020: 21; 1728-33
Yadav, A. K., Khan, M.E., Khan T.A., A comprehensive review on performance, emission and combustion characteristics of diesel engines fuelled with algae oil and methyl ester, WEENTECH Proceedings in Energy, 6 (2) (2020) 160-168
Khan T.A., Yadav, A.K, Khan, T.A., Khan M.E. Microalgae: A Promising Third Generation Renewable Energy Source for I.C. Engines , Journal
of Automobile Engineering and Applications, (2020) 7(1);1-5,
Yadav A.K., A. Pal, ME Khan. Optimization of Production and Performance of Biodiesel through Optimization Techniques: A Review, International Journal of Advance Research and Innovation, Vol.2,
Issue 4 (2014) 763-766
Yadav, A.K., S Singh, G Gupta, Solar Air- Conditioning: Design for a Compressor-Less System using, Peltier Effect, International Journal of
Advance Research and Innovation, Volume 2, Issue 2 (2014) 429-432
Yadav, A.K., Optimum Production of Biodiesel from an Underutilized and Potential Feed stock, Kusum Seed Oil., Iranica Journal of Energy and Environment 8(1): 6-10, 2017
Khan, O., ME Khan, A Kumar, S Kumar, Study on Some Advanced Techniques to Produce Biodiesel from Non-edible Oils, International Journal of Advance Research and Innovation,Vol. 5, Issue 1(2017) 34-38
Malviya, A., AK Bera, MD Pandey, L Gupta, P Gautam, A Kumar, Production of biodiesel from mahua oil by mechanical stirring and its performance testing on a diesel engine, International Journal of
Advance Research and Innovation, Volume 5 Issue 3 (2017) 372-375
Yadav, A.K., S Singh, U Ghosh, G Gupta, Design and Manufacturing of Honing Tool for Drilling Machine, International Journal of Advance Research and Innovation Volume 2, Issue 2 (2014) 433-435
Singh, S., A.K., Yadav, B Singh, Thermal Energy Harvesting using BaTiO3 Based Ferroelectric Ceramics: A Review, International Journal of
Advance Research and Innovation, Volume 6, Issue 3(2018) 209-211
Kumar, N., A. K. Yadav, A. Dewangan, and M. Kumar, CFD Based Investigation of Thermophoresis Effect on Microparticles in Micro Channel, Advances in Mechanical and Energy Technology, Springer,
Lecture Notes in Mechanical Engineering, pp. 285-296, ISBN 978-981-19-1617-5. DOI:https://doi.org/10.1007/978-981-19-1618-2_31, June
Dewangan, A., B. Singh, A. Srivastava, A.Srivastava, A. K. Yadav, A Broad Review ofBiodiesel Feedstocks with Competency to Replace
Diesel, Advances in Mechanical and Energy Technology, Springer, Lecture Notes in Mechanical Engineering, pp. 323-331, ISBN 978-981-19-1617-5.
DOI:, https://doi.org/10.1007/978-981-19-1618-2_28, June 2022.
Ahmad, A., A. Singh, D. K. Singh & A. K. Yadav, An Experimental Investigation of the Effect of Diethyl Ether as an Additive on the Performance of a Single Cylinder Diesel Engine, Recent Trends in
Thermal and Fluid Sciences, Lecture Notes in Mechanical Engineering, pp. 69–75, ISBN: 978-981-19-3498-8, DOI: 10.1007/978-981-19-3498-8_7,
Nov.2022.
Singh, S., A. K. Yadav, N. Kumar , U.K. Choudhury, M. Kumar, Investigation on lead free ferroelectric [(Ba0.825+xCa0.175-x)(Ti1-xSnx)O3] ceramics for energy storage density and thermal energy harvesting capacity, Recent Advances in Manufacturing and
Thermal Engineering, Lecture Notes in Mechanical Engineering, ISBN: 978-981-19-8516-4, Feb. 2023,Springer.
S. Patel, M. Patel, A. Patel, C. Sanghani, and D Patel, “Development of the Electro-Magnetic Brake,” IJIRST–International Journal for Innovative Research in Science & Technology, 1(12) (2015).
DOI: https://doi.org/10.37591/joaea.v9i3.6888
Refbacks
- There are currently no refbacks.