The Rheological Effect of SiO2 Nanoparticles Additives for NBR/CR Blends

Authors

  • Ali I. Al-Mosawi
  • Mohammed H. Al-Maamori
  • Shaymaa Abbas Abdulsada

DOI:

https://doi.org/10.37591/jocc.v4i3.83

Keywords:

NBR/CR blends, silicon oxide nanoparticles, rheological properties

Abstract

The rheological alteration of NBR/CR after adding various nano-quantities of silicon oxide (0–50) wt.% was studied. The rheological properties that were tested are viscosity, scorch time, cure time and max torque. Oscillating disk rheometer was used for measuring the above properties. The experimental results have shown that the silicon oxide additives have a good effect on viscosity and max torque during vulcanization, but at the same time the scorch and cure time decrease.

 

Cite this Article

Al-Maamori Mohammed H, Al-Mosawi Ali I, Shaymaa Abbas Abdulsada. The Rheological Effect of SiO2 Nanoparticles Additives for NBR/CR Blends. Journal of Catalyst & Catalysis. 2017; 4(3): 1–4p.

 

Author Biographies

  • Ali I. Al-Mosawi

    University of Miskolc, 3515 Miskolc-Egyetemváros, Hungary

  • Mohammed H. Al-Maamori

    Departmentof Polymer, College of Engineering Materials, Babylon University, Babylon, Hilla, Iraq

  • Shaymaa Abbas Abdulsada

    University of Miskolc, 3515 Miskolc-Egyetemváros, Hungary

Downloads

Published

2018-06-12

Issue

Vol. 4 No. 3 (2017)

Section

Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.