Modeling and Numerical Simulation of Forged Ploughing Disc

Authors

  • Ramesh Rudrapati Assistant Professor, Department of Mechanical Engineering, Institute of Technology, Hawassa University, Ethiopia.
  • Ramulu P. J.
  • Beza T.
  • Verma R.K
  • Kolhe S.

DOI:

https://doi.org/10.37591/joeam.v10i1.2501

Keywords:

Forging operation, forging parameters, DEFORM-3D software, optimization

Abstract

Forging operation is the oldest metal forming process known for producing a product of a reduced void and improved physical properties which make it suitable for manufacturing of a ploughing disc that can be applied in sticky soil, for deep plough. It can also be used safely in stony and stumpy soil without much danger of breakage. This study focuses on identifying appropriate parameters for the manufacturing of a proper geometry of a plough disc. Three dimensional and two-dimensional modeling of the components was carried out using CATIA V5R19 software. The simulation and the stability are validated using DEFORM-3D software for manufacturing of a good plough disc. The obtained result allows finding optimum forging parameters for manufacturing the safest value for manufacturing good plough disc geometry.

References

Ramulu PJ, Beza T, Rudrapati R, Verma RK, et al. Modeling and Numerical Simulation of Forged Ploughing Disc. Journal of Experimental & Applied Mechanics. 2019; 10(1): 35–42p.

Downloads

Published

2019-05-01

Issue

Vol. 10 No. 1 (2019)

Section

Research Article

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.