Design Simulation and Analysis of Zeta Converter for Speed Control of BLDC Motor

Authors

  • Parmar Bhupendrabhai Devang Assistant Professor, Department of Electrical Engineering, Vyavsayi Vidhya Pratishthan (V.V.P.) Engineering College, Rajkot, Gujarat
  • Alpesh Adesara Assistant Professor, Department of Electrical Engineering, Vyavsayi Vidhya Pratishthan (V.V.P.) Engineering College, Rajkot, Gujarat
  • Anil Vasani Associate Professor, Department of Electrical Engineering, Vyavsayi Vidhya Pratishthan (V.V.P.) Engineering College, Rajkot, Gujarat
  • Anoop Budhrani Lab Technician, Department of Electrical Engineering, Vyavsayi Vidhya Pratishthan (V.V.P.) Engineering College, Rajkot, Gujarat

Abstract

In recent years, usage of variable speed drive systems has been increasing in various low power applications like automobile industries, domestic appliances, etc. To save the energy consumption of devices, there is a necessity in the usage of green and eco-friendly electronics. For improvement in power factor and speed control, BLDC with Zeta converter is proposed in this paper. Zeta converter is used for voltage regulation due to its wide range of speed control of BLDC Motor by controlling Voltage of DC link Capacitor. And unity power factor with low harmonics distortion is achieved. Here simulation environment with PSIM Version 9.0.3.400 Software.

References

Sanjeev Singh, Bhim Singh “A voltage-controlled PFC Cuk converter-based PMBLDC drive for air-conditioner”. IEEE Transactions on Industry Application. March/April 2012; 48(2): 832 - 838.

M. pandi Maharajan, P. Muthu, M. Palpandian, S. Kannadasan. “Analysis of Low harmonics and high efficient BLDC motor drive system for automotive application”. 2011 international conference on recent advancement in electrical, electronics and control engineering. 15-17 Dec. 2011; Sivakasi, India. US: IEEE Press; 2012.

Tilak Gopalarathnam, Hamid a Toliyat “Input current shaping in BLDC motor drives using a new converter topology” iecon’01: the 27th annual conference of the IEEE industrial electronics society. 29 November - 2 December 2001; Denver, CO, USA. US: IEEE Press; 2002.

B. Singh, S. Singh “Single-phase power factor controller topologies for permanent magnet brushless dc motor drives” IET Power Electronics. 2009; 3(2): 147-175.

Elizabeth Alphonsa Jose, Thomas k.P. “Matlab Simulink model of Cuk pf corrected BLDC motor drive” International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering. June 2013; 2(6): 2539- 2547.

Bikram Das, Suvamit Chakraborty, Abanishwar Chakraborti, Prabir Ranjan Kansari. “Performance analysis of BLDC motor using basic switching converter”. International Journal of Innovative Technology and Exploring Engineering (IJITEE). December 2012; 2(1): 11-14.

G. Ranjithkumar, Prasad, M. Arun Noyal doss “Improve the transient response of speed and torque ripple minimization of the BLDC motor by varies controller” 2012 International Conference on Computer Communication and Informatics (ICCCI- 2012). January 10-12, 2012; Coimbatore, India. US: IEEE Press; 2012.

Thomas M. Blooming, Daniel J. Arnovale, “Application of IEEE 519-1992 harmonic limits” Conference Record of 2006 Annual Pulp and Paper Industry Technical Conference. 18-23 June 2006; Appleton, WI, USA. US: IEEE Press; 2006.

S. Khalid, Bharti Dwivedi “Power quality issue, problems, standards & their effects in the industry with corrective means”. International Journal of Advances in Engineering & Technology. May 2011; 1(2): 1-11.

J. Karthikeyan, R. Dhana Sekaran “DC-DC converter CSI fed BLDC motor for Defense application” International Conference on Recent Advancements in Electrical, Electronics, and Control Engineering, 15-17 December 2011; Sivakasi, India. US: IEEE Press; 2012.

Chen B., Xie Y.X., Tang F. “A Novel three-phase buck PFC converter based on one-cycle control’.2006 International Conference on Power System Technology. 22-26 October 2006; Chongqing, China. US: IEEE Press; 1–7 p.

J. Cardesin, J. Sebastian, P. Villegas, et, al. “Average small-signal model of buck converter used as power factor pre regulator.” Conference Record of the 2002 IEEE Industry Applications Conference. 37th IAS Annual Meeting. 13-18 October 2002; Pittsburgh, PA; USA. US: IEEE Press; December 2002. 2147–2151 p.

Lin c.t., Hung c.w., Liu c.w.: ‘Sensorless control for four switches three-phase brushless dc motor drives. Conference Record of the 2006 IEEE Industry Applications Conference Forty-First IAS Annual Meeting. 8-12 October 2006; Tampa, fL, USA. US: IEEE Press; December 2006. 2048–2053 p.

Kazunori N., Katsuya h., Shinji k., Mutsuo n.: ‘Two buck choppers built-in single-phase one stage PFC converter with reduced dc voltage ripple and its specific control scheme’. 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition 24-28 February 2008; Austin, USA. US: IEEE Press; May 2008. 1378–1383 p.

Singh B., Reddy H.N., Murthy S.S.: ‘Gain scheduling control of permanent magnet brushless DC motor’. IE (India) Journal- EL, 2003; 84: 52–62.

Downloads

Published

2022-03-07

Issue

Vol. 11 No. 3 (2021)

Section

Research Article

License

Journal Title:

Title of the Paper:

Corresponding Author’s Information:

Name: Address:

E-mail:

Contact Number:

It is herein agreed that: The copyright to the above-listed unpublished and original article is transferred to STM Journals.

This copyright transfer covers the exclusive right to reproduce and distribute the contribution, including reprints, translations, photographic reproductions, microform, electronic form (offline, online), or any other reproductions of similar nature.

I/We declare that above manuscript is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

 I/ We warrant(s) that his/her/their contribution is original, except for such excerpts from copyrighted works as may be included with the permission of the copyright holder and author thereof, that it contains no libelous statements, and does not infringe on any copyright, trademark, patent, statutory right, or propriety right of others.

I/We will not publish his/her/their above said contribution anywhere else without the prior written permission of the publisher unless it has been changed substantially. I/We also agree to the authorship of the article in the following order: Author(s) Name Signature(s)

1. ________________

2. ________________

3. ________________

4. ________________

The author(s) agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal (comments if any to the editor can be added below).