Polymers with Non-polar Lubricants: Degradation and Triboelectric Performance

Authors

  • Sakshi Sharma

Abstract

Triboelectric nanogenerators (TENGs) transform electrical energy from kinetic energy with the assistance of electrostatic interactions and triboelectrification. TENGs provide countless benefits, together with cheap prices, straightforward processing, and broad enforceability. In solid interaction TENGs, wear and friction, moreover, abbreviate their life span. In this study, we assessed the tribological efficiency and power efficiency of polymeric in TENG devices with non-polar lubrication limiting friction and wear. The viscosity of the lubricant together with the wetting and mechanical attributes of the polymers influenced the lubricant-dependent tribological conduct of the former Additionally enhanced and used to power the electronic device were the electrical outputs of the lubricant-based TENG system. The comprehensive review of the tribological properties of lubricantbased TENGs in this study encourages the constancy of the lubricant-based TENG sy

References

Chalasani S, Conrad JM. A survey of energy harvesting sources for embedded systems. In IEEE SoutheastCon 2008 (pp. 442–447). IEEE.

Raghunathan V, Kansal A, Hsu J, Friedman J, Srivastava M. Design considerations for solar energy harvesting wireless embedded systems. In IPSN 2005. Fourth International Symposium on Information Processing in Sensor Networks, 2005. (pp. 457–462). IEEE.

Abdin Z, Alim MA, Saidur R, Islam MR, Rashmi W, Mekhilef S, Wadi A. Solar energy harvesting with the application of nanotechnology. Renewable and sustainable energy reviews. 2013; 26:837–52.

Li, S.; Yuan, A.J.; Lipson, H. Ambient wind energy harvesting using cross-flow fluttering. J. Appl. Phys. 2011, 109, 026104.

Tan, Y.K.; Panda, S.K. Optimized wind energy harvesting system using resistance emulator and active rectifier for wireless sensor nodes. IEEE Trans. Power Electron. 2010, 26, 38–50.

Tan, Y.K.; Panda, S.K. Measurement. Self-autonomous wireless sensor nodes with wind energy harvesting for remote sensing of wind-driven wildfire spread. IEEE Trans. Instrum. Meas. 2011, 60, 1367–1377.

Lee, J.S.; Yong, H.; Choi, Y.I.; Ryu, J.; Lee, S. Stackable Disk-Shaped Triboelectric Nanogenerator to Generate Energy from Omnidirectional Wind. Int. J. Precis. Eng. Manuf. Technol. 2021, 9,557–565.

Yong, H.; Chung, J.; Choi, D.; Jung, D.; Cho, M.; Lee, S. Highly reliable wind-rolling triboelectric nanogenerator operating in a wide wind speed range. Sci. Rep. 2016, 6, 33977.

Carrara, M.; Cacan, M.R.; Toussaint, J.; Leamy, M.J.; Ruzzene, M.; Erturk, A. Metamaterialinspired structures and concepts for elastoacoustic wave energy harvesting. Smart Mater. Struct.

, 22, 065004.

Khan, T.A.; Alkhateeb, A.; Heath, R.W. Millimeter Wave Energy Harvesting. IEEE Trans. Wirel. Commun. 2016, 15, 6048–6062.

Younesian, D.; Alam, M.-R. Multi-stable mechanisms for high-efficiency and broadband ocean wave energy harvesting. Appl. Energy 2017, 197, 292–302.

Chung, J.; Heo, D.; Shin, G.; Chung, S.H.; Hong, J.; Lee, S. Water behavior based electric generation via charge separation. Nano Energy 2020, 82, 105687.

Le, T.; Mayaram, K.; Fiez, T. Efficient Far-Field Radio Frequency Energy Harvesting for Passively Powered Sensor Networks. IEEE J. Solid-State Circuits 2008, 43, 1287–1302.

Masotti, D.; Costanzo, A.; Del Prete, M.; Rizzoli, V. Genetic-based design of a tetra-band highefficiency radio-frequency energy harvesting system. IET Microw. Antennas Propag. 2013, 7, 1254–1263.

Zungeru, A.M.; Ang, L.-M.; Prabaharan, S.; Seng, K.P. Radio Frequency Energy Harvesting and Management for Wireless Sensor Networks. In Green Mobile Devices and Networks: Energy

Optimization and Scavenging Techniques; CRC Press: Boca Raton, FL, USA, 2012; pp. 341–368

Downloads

Published

2023-02-06

Issue

Vol. 9 No. 3 (2022)

Section

Review Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.