Open Access Open Access  Restricted Access Subscription or Fee Access

Design and Topology Optimization of Housing Bracket of Starter Motor

Srikonda Udaykiran, Santosh B.Jadhav



Starter engine is an electric engine which gives electro-mechanical movement to begin the inside ignition motor. The electric starter guarantees that anybody could without much of a stretch beginning and run an inside burning motor for any traveler vehicles. Starter engine lodging section quality and weight has been constantly a worry which may prompt operational cost high and strength life. This examination presents the plan of model in CATIA software and topology optimization in ANSYS software for existing structure to meet the item weight and fatigue life cycle. In the improvement of lodging section, limited component investigation ANSYS software is utilized for computing the stress and afterward the weight is to be enhanced. The upgraded new lodging section is to be proposed for new starter ventures to catch new business and the plan to be executed to decrease cost in item ionized starters.

Keywords: FEA, UTM, Topology optimization

Cite this Article

Srikonda Udaykiran, Prof. Santosh B.Jadhav. Design and Topology Optimization of Housing Bracket of Starter Motor. Recent Trends in Fluid Mechanics. 2020; 7(2): 5–11p.

Full Text:



Rishikesh Patil, and Hemant Chaudhari studied the Failure Analysis and Optimization in Design of Drive End Bracket of Starter Motor ISSN 2454- 535X journal Volume 3 2017

Varatharaj Neelakandan, Thulasirajan Gnaesan, Praveen Chackrapani Rao Studied Nvh Analysis and Measurement Correlation of Electrical Starter Motor for Automotive Vehicles WRFER International Conference PP01, 2018

Dyi Zen Tan studies the Design and Construction of Motor Mounts for Renewable Energy Vehicle 2008

Bhairavanath Subhash Jadhav, Dattatray P.Kambale studies the Design & Mass Optimization of Gear using Composite material International Journal of Scientific Development and Research (IJSDR) Volume 3 PPNo 01, August 2018

Senthil Ram Nagapillai Durairaj, Thulasirajan Ganesan, and Praveen Chakrapani Rao studies the Starter Motor Light Weighting through Use of Alternate Materials SAE International journal 2017

Senthil Ram Nagapillai Durairaj, Thulasirajan Ganesan, and Praveen Chakrapani Rao studied the Vibration Analysis on Magnesium Alloy Housing and Analysis of Resonant Frequency on the Housing between Magnesium and Aluminium Alloy SAE International journal 2017

Xianghua Xing, Peng Wei, and Michael Yu Wang studied the Finite element-based level set method for structural optimization International Journal 2009

Mordike B.L. and Ebert T., “Magnesium Properties-Applications-Potential”, Materials Science and Engineering A302 (2001) 37-45

Blawert C., Hort N. and Kainer K.U., “Automotive Applications of Magnesium and Its Alloys”, Trans. Indian Inst. Met., Vol.57, No. 4, August 2004

Kagan, V., Chung, J., and McPherson, R., "Family of High Modulus (HMG) Nylon Based Plastics Increases Mileage and Reduce Weight," SAE Technical Paper 2001-01-3423



  • There are currently no refbacks.

Copyright (c) 2020 Recent Trends in Fluid Mechanics