Open Access Open Access  Restricted Access Subscription or Fee Access

A Review of Dynamic Wireless Charging System for Electric Vehicles and IoT Technology

Venkateswara Rao Kurra, Jyothsna Thummala, Amarendra Reddy B.

Abstract


Dynamic charging of Electric Vehicles (EVs) by Wireless Power Transfer (WPT) is a key emerging technology in the field of power electronics. Even though Electric vehicles (EVs) are beneficial to the environment, they have their own limitations with respect to charging difficulties and mileage anxiety. These problems are overcome by dynamic wireless power transfer (DWPT) technology. By DWPT technology the size of the main storage battery can be reduced, significantly reducing cost and weight. In a typical dynamic charging system coil embedded in the roadway, referred to as primary pads, are energized sequentially as a vehicle mounted coil moves over them. Magnetic coupling between the coils allows power to be transferred to the EV. This paper presents IoT technology, cyber-attacks, and security. Using magnetic (inductive) coupling, a primary pad powered by the grid wirelessly transfers energy to a secondary pad placed beneath an EV in a conventional WPT charging setup. Power converters can be categorised into two main groups based on their location: transmitter-side and receiver-side conversion. Transmitter-side conversion can be single- or dual-stage, whereas receiver-side conversion can be accomplished with a rectifier alone or with a rectifier plus dc-dc converter.


Full Text:

PDF

References


Thomas CES. Transportation options in a carbon-constrained world: “Hybrids,plug-in hybrids, biofuels, fuel cell electric vehicles, and battery electric vehicles”. Int J Hydrog Energy 2009;34(23):9279–96.

Dickerman L, Harrison J.”A new car, a new grid. IEEE Power Energy Mag”2010;8(2):55–61.

B. Regensburger, A. Kumar, S. Sinha, and K. Afridi, “High-performance 13.56-MHz large air-gap capacitive wireless power transfer system for electric vehicle charging,” in Proc. IEEE 19th Workshop Control Model. Power Electron., 2018, pp. 1–4.

J. Shin et al., “Design and implementation of shaped magnetic-resonancebased wireless power transfer system for roadway-powered moving electric vehicles,” IEEE Trans. Ind. Electron., vol. 61, no. 3, pp. 1179–1192,Mar. 2014.

M. R. Barzegaran, H. Zargarzadeh, and O. A. Mohammed, “Wireless power transfer for electric vehicle using an adaptive robot,” IEEE Trans.Magn., vol. 53, no. 6, Jun. 2017, Art. no. 7205404.

Ze Zhou , Liyan Zhang, Zhitao Liu , Qihong Chen, Rong Long, and Hongye Su ,” Model Predictive Control for the Receiving-Side DC–DC Converter of Dynamic Wireless Power Transfer” IEEE Transactions On Power Electronics, Vol. 35, No. 9, September 2020

Mohamed, A.A.; Shaier, A.A.; Metwally, H.; Selem, S.I. “Interoperability of the universal WPT transmitter with different receivers for electric vehicle inductive charger”. eTransportation 2020, 6, 100084.enhance sustainable mobility. Appl. Energy 2016, 179, 413–425.

Bi, Z.; Kan, T.; Mi, C.C.; Zhang, Y.; Zhao, Z.; Keoleian, G.A. “A review of wireless power transfer for electric vehicles: Prospects to enhance sustainable mobility”. Appl. Energy 2016, 179, 413–425.

Arteaga, J.M.; Aldhaher, S.; Kkelis, G.; Yates, D.C.; Mitcheson, P.D. Multi-MHz IPT Systems for Variable Coupling. IEEE Trans. Power Electron. 2017, 33, 7744–7758.

Li, S.; Mi, C.C.”Wireless Power Transfer for Electric Vehicle Applications.” IEEE J. Emerg. Sel. Top. Power Electron. 2014, 3, 4–17.

Takanashi, H.; Sato, Y.; Kaneko, Y.; Abe, S.; Yasuda, T. A large air gap 3 kW wireless power transfer system for electric vehicles. In Proceedings of the 2012 IEEE Energy Conversion Congress and Exposition (ECCE), Raleigh, NC, USA, 15–20 September 2012;pp. 269–274.

International Commission on Non-Ionizing Radiation Protection (ICNIRP). Guidelines for Limiting Exposure to Time-Varying Electric and Magnetic Fields (1 Hz to 100 KHz). Health Phys. 2010, 99, 818–836. https://www.icnirp.org/cms/upload/publications/ICNIRPLFgdl.pdf

(ICNIRP) International Commission on Non-Ionizing Radiation Protection. Guidelines for limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to 300 GHz). Health Phys. 1998, 74, 494–522. https://www.icnirp.org/cms/upload/publications/ICNIRPemfgdl.pdf

Panchal, C.; Stegen, S.; Lu, J.-W. Review of static and dynamic wireless electric vehicle charging system. Eng. Sci. Technol. Int. J.2018, 21, 922–937.

Ahmad, A.; Alam, M.S.; Chabaan, R. A Comprehensive Review of Wireless Charging Technologies for Electric Vehicles. IEEE Trans. Transp. Electrif. 2017, 4, 38–63.

Lu, F.; Zhang, H.; Hofmann, H.; Mi, C.C. A Dynamic Charging System with Reduced Output Power Pulsation for Electric Vehicles.IEEE Trans. Ind. Electron. 2016, 63, 6580–6590.

García-Vázquez, C.A.; Llorens-Iborra, F.; Fernández-Ramírez, L.M.; Sánchez-Sainz, H.; Jurado, F. Comparative study of dynamic wireless charging of electric vehicles in motorway, highway and urban stretches. Energy 2017, 137, 42–57.

Zaheer, A.; Covic, G.A.; Kacprzak, D. A Bipolar Pad in a 10-kHz 300-W Distributed IPT System for AGV Applications. IEEE Trans. Ind. Electron. 2013, 61, 3288–3301.

A. Zaheer, D. Kacprzak, and G. A. Covic, “A bipolar receiver pad in a lumped IPT system for electric vehicle charging applications,” in Proc.IEEE Energy Convers. Congr. Expo., 2012, pp. 283–290.

Mude, K.N.; Aditya, K. Comprehensive review and analysis of two-element resonant compensation topologies for wireless inductive power transfer systems. Chin. J. Electr. Eng. 2019, 5, 14–31

Keeling, N.A.; Covic, G.A.; Boys, J.T. A Unity-Power-Factor IPT Pickup for High-Power Applications. IEEE Trans. Ind. Electron.2009, 57, 744–751.

Wang, C.-S.; Stielau, O.; Covic, G. Design Considerations for a Contactless Electric Vehicle Battery Charger. IEEE Trans. Ind.Electron. 2005, 52, 1308–1314.

Shevchenko, V.; Husev, O.; Strzelecki, R.; Pakhaliuk, B.; Poliakov, N.; Strzelecka, N. Compensation Topologies in IPT Systems:Standards, Requirements, Classification, Analysis, Comparison and Application. IEEE Access 2019, 7, 120559–120580.

C. S.Wang, G. A. Covic, and O. H. Stielau, “Power transfer capability and bifurcation phenomena of loosely coupled inductive power transfer systems,”IEEE Trans. Ind. Electron., vol. 51, no. 1, pp. 148–157, Feb. 2004.

S. Li, W. Li, J. Deng, T. D. Nguyen, and C. C. Mi, “A double-sided LCC compensation network and its tuning method for wireless power transfer,”IEEE Trans. Veh. Technol., vol. 64, no. 6, pp. 2261–2273, Jun. 2015.

Patil, D.; McDonough, M.K.; Miller, J.M.; Fahimi, B.; Balsara, P.T. Wireless Power Transfer for Vehicular Applications: Overview and Challenges. IEEE Trans. Transp. Electrif. 2018, 4, 3–37.

S. Pattar, R. Buyya, K. Venugopal, et al., “Searching for the IoT Resources: Fundamentals, Requirements, Comprehensive Review and Future Directions,” Communications Surveys & Tutorials, pp. 1-32, Apr.2018.

M. Rana, “Attack Resilient Wireless Sensor Networks for Smart ElectricVehicles,” IEEE Transactions on Energy Conversion, vol. 1, no. 2, pp. 1-4, Apr.2017.

Y. Fraiji, L. B. Azzouz, W. Trojet, and L. A. Saidane, “Cyber security issues of internet of electric vehicles,” in 2018 IEEE Wireless Communications and Networking Conference (WCNC). IEEE, 2018,pp. 1–6.

J. E. Rubio, C. Alcaraz, and J. Lopez, “Addressing security in ocpp:Protection against man-in-the-middle attacks,” in 2018 9th IFIP InternationalConference on New Technologies, Mobility and Security(NTMS). IEEE, 2018, pp. 1–5


Refbacks

  • There are currently no refbacks.


Copyright (c) 2023 Trends in Electrical Engineering

eISSN: 2249-4774