Vol. 6 No. 1 (2016)

Review Articles

• Modeling of Rubber Bush Mould by using DME Standard

  H H Makwana, M S Kagathara, A V Vaishnav

  1-7

  • Requires Subscription PDF (USD 30)

• CFD Analysis of 4-Stroke Engine: A Review

  DilbagSingh C Mondloe, Lina M Rola

  14-17

  • Requires Subscription PDF (USD 30)

• Component Fastening by Using Snap-On Tools Replacing Traditional Fasteners

  Niraj Vangani, Manhar Kagthara

  31-34

  • Requires Subscription PDF (USD 30)

• Solar Humidity Control Unit with Hot Water Generation

  Swadesh Pratap Singh, Anil Singh Tomar, Sachindra Singh, C S Malvi

  8-13

  • Requires Subscription PDF (USD 30)

• Morphological Analysis of Nitride Coated Steel for Industrial Application

  Pina Bhatt, H N Shah

  18-22

  • Requires Subscription PDF (USD 30)

• Effect of Various Dielectric Fluids on Performance of EDM: A Review

  C.R. Sanghani, G.D. Acharya

  55-71

  • Requires Subscription PDF (USD 30)

• Effect of Electrode Extension and Width of the Plate on Distortion and Residual Stresses Using Submerged Arc Welding Process

  Yellappa M, N Lakshmana Swamy, H M Somashekar, Giriswamy B G, Harisha SK

  23-30

  • Requires Subscription PDF (USD 30)

• INFLUENCE OF SULPHUR DIFFUSION ON THE SURFACE OF FURAN NO BAKE CASTING- A REVIEW

  Kashyap V Mehta, Shivang S Jani, Dr. G. D. Acharya

  72-78

  • Requires Subscription PDF (USD 30)

• Fuzzy Modeling to Specify Various Machining Parameters in Electrical Discharge Machining (EDM) of INCONEL625 Using Copper Electrode

  P M Radia, M S Kagathara, H G Acharya

  35-42

  • Requires Subscription PDF (USD 30)

• Effect of Blade-Casing Rub Event on Blade, Casing and Turbine Shaft in Gas Turbine Engine

  Harisha S.K, Shivaraj Kumar D.N., Ramachandra. K, Narendra Babu K.

  43-54

  • Requires Subscription PDF (USD 30)

• SHEQ to Shake the Car Development for Tomorrow: Part II (Infrastructural Shortfall and Growth @ Future-Cars)

  Priyavrat Thareja

  79-95

  • Requires Subscription PDF (USD 30)