Open Access Open Access  Restricted Access Subscription or Fee Access

Advancement and Experimental Investigation of Voice Coil Actuator utilizing Flexural Bearing

Shrishail B Sollpaur, M.S. Patil, S.P. Deshmukh

Abstract


Flexural components are very ideal over regular inflexible body systems where exceptionally exact and exact movement is vital in the scope of microns. To accomplish spotless and exact movement, we propose another outline of voice loop actuator. Fitting loop and magnet is chosen viewing the most extreme power as connected. Computer aided design demonstrate is readied and limited component examination (FEA) is done to decide the solidness. Voice coil engine (VCM) parts are made and amassed. This VCM is incorporated with dSPACE DS1104 Research and development controller to give wanted abundance and recurrence of movement through straight momentum speaker (LCAM). The uprooting of yield shaft of VCM is detected by straight factor differential transformer (LVDT) which gives change in yield voltage comparing to the dislodging of yield shaft. The power diversion attributes are noted down for FEA and also trial system and firmness in both the cases is resolved. It is watched that there is close understanding amongst FEA and experimental outcomes.


Keywords


LCAM; LVDT; Voice coil Motor; FEA

Full Text:

PDF

References


S. Awtar, A. H. Slocum, Design of parallel kinematic XY flexural mechanism, Proceedings of IDETC/CIE 2005 ASME 2005 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference, Long Beach, California, USA.

Lobontiu N., 2003, Compliant Mechanisms: Design of Flexure Hinges, CRC Press.

Qing Yao, J. Dong, P.M. Ferreira, Design, analysis, fabrication and testing of a parallel-kinematic micropositioning XY stage, International Journal of Machine Tools & Manufacture 47 (2007) 946–961.

Hwa Soo Kim, Young Man Cho, Design and modeling of a novel 3-DOF precision micro-stage, Mechatronics 19 (2009) 598–608.

Yangmin Li, Qingsong Xu, Modeling aand performance evalutrion of a flexure-based XY parallel micromanipulator, Mechanism and machine Theory, 44 (2009) 2127-2152.

Y. Tian, B. Shirinzadeh, D. Zhang, X. Liu, D. Chetwynd, Design and forward kinematics of the compliant micro-manipulator with leaver mechanisms, Precision Engineering 33 (2009) 466-475.

Shrishail Sollapur, Suhas Deshmukh (2014) XY Scanning Mechanism A Dynamic Approach, Int. J. Mech. Eng. & Rob. Res. 2014, ISSN 2278 – 0149 Vol. 3, No. 4.

Shorya Awtar and Jason Meyer Quint (2012), ―In-plane Flexure- Based Clamp. Precision Engineering Vol. 36, pp.658– 667.

Zubir MNM, Shirinzadeh B. Tian Y (2007), ―Development of novel flexure-based microgripper for high precision micro-object manipulation‖, Sensors and Actuators A:Physical ,vol 134, pp.231-8.




DOI: https://doi.org/10.37591/joma.v5i2.693

Refbacks

  • There are currently no refbacks.