Dynamic Performance Analysis of Non-metallic Spur Gear subjected to Variable Loads and Speeds
Abstract
The thrust for design and development of nonmetallic gear results in fabrication of inexpensive cement reinforced polypropylene based composite material spur gear. In this work, several experiments are conducted under variable loads and speeds and subsequently the resulting effect of heat emission on the performance of the gear is analyzed. A laboratory made gear test-rig is modified and suitably retrofitted; while pure polypropylene and 10 wt% cement reinforced spur gears are selected and experiment is conducted under preset load and speed. The rise in surface temperature was captured by Infra-red (IR) camera supported by inter-phased IRBIS-3 PLUS software and subsequently, captured data are quantified and studied. Test results show significant increase in heat emission when the test speed reaches a critical value of the gear. Further, experiments are also conducted with cracks on the tooth root that show distinct influence on the contact flanks surface temperature of the gear. Experiment results validate that dynamic performance depends on the factors like operating speed, applied load, duration of operation and percentage of cement fillers etc.
Keywords: Non-metallic spur gear; surface temperature; applied load; operating speed, wear
Cite this Article
Jagannath Sardar, Dibakar Bandopadhya. Dynamic Performance Analysis of Non-metallic Spur Gear subjected to Variable Loads and Speeds. Trends in Machine Design. 2015; 2(3): 1–19p.
Published
Issue
Section
License
Declaration and Copyright Transfer Form
(to be completed by authors)
I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.
- I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
- I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
- I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
- I/We also agree to the authorship of the article in the following order:
Author’s name
1. ________________
2. ________________
3. ________________
4. ________________
| We Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal. |