Investigation and Evaluation of Wear Characteristics of A Nonmetallic Spur Gear
Abstract
A thermoplastic composite material designed and developed for fabrication of nonmetallic composite spur gear. The composite is fabricated using Portland Pozzolanic Cement (PPC) as filler material into the polypropylene matrix followed by injection molding technique. However, geometrical structure of the developed product depends on the parameter like loading-unloading condition and temperature fluctuation that severely influence the material performance and shorten the product life. In the present work, the composite spur gear material is tested to evaluate its friction and wear characteristics in adhesive and abrasive wear modes. Weight loss due to wear of the composite gear is evaluated through direct measurement under a specific load and running condition. It is observed that the adhesive wear rate significantly reduced when the cement filler loading increases. This is because shear strength and surface energy of the composite material changes while toughness and hardness of the material improves due to strengthening by cement fillers.
Keywords: Composite, spur gear, coefficient of friction, wear
Published
Issue
Section
License
Declaration and Copyright Transfer Form
(to be completed by authors)
I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.
- I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
- I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
- I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
- I/We also agree to the authorship of the article in the following order:
Author’s name
1. ________________
2. ________________
3. ________________
4. ________________
| We Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal. |