Evaluation of Abrasive Grinding Parameters in Crankshaft Manufacturing

Authors

  • Jethva Priyanshu P. Department of Mechanical Engineering, V.V.P. Engineering College (affiliated to Gujarat Technological University), Rajkot, Gujarat
  • Nathvani Darshan Student, Department of Mechanical Engineering, Vyavasayi Vidya Pratishthan Engineering College, Gujarat Technological University, Rajkot, Gujarat,
  • Sherasiya Sarfaraj G. Student, Department of Mechanical Engineering, Vyavasayi Vidya Pratishthan Engineering College, Gujarat Technological University, Rajkot, Gujarat,
  • Hardik P. Hindocha Professor, Department of Mechanical Engineering, Vyavasayi Vidya Pratishthan Engineering College, Gujarat Technological University, Rajkot, Gujarat,

DOI:

https://doi.org/10.37591/tmet.v9i3.3583

Keywords:

Evaluation, Grinding, Crank shaft, Machining parameters, Temperature, Manufacturing, Taguchi’s, Machine tool

Abstract

Grinding is a metal cutting operation performed by means of rotating abrasive tool, called “Grinding wheel”. Grinding is done on surface of almost all conceivable shapes and materials of all kinds. In grinding, it is possible to achieve very accurate dimensions and smoother surface finish in a very short time and it is only a method after hardening. High temperature to the tune of the 1000 to 1400°C is usually encountered in grinding, resulting into rapid grain wear and high induced surface. But if temperature is going out of range during grinding process, a high generation of heat and corrosion problem and noise generate. In this experiment optimizing or evaluating the parameters in abrasive grinding which done on conventional lathe like cylindrical grinding in the crankshaft manufacturing process.

References

Cite this Article

Jethva Priyanshu P., Nathvani Darshan, Sherasiya Sarfaraj G., Hardik P. Hindocha. Evaluation of Abrasive Grinding Parameters in Crankshaft Manufacturing. Trends in Mechanical Engineering & Technology. 2019; 9(3): 13–15p.

Downloads

Published

2019-12-14

Issue

Vol. 9 No. 3 (2019)

Section

Research Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

  • I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.
  • I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).
  • I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.
  •  I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. ________________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.