Open Access Open Access  Restricted Access Subscription or Fee Access

A Review on Structural Evaluation of Flexible Pavements using Falling Weight Deflectometer

Ujjval J. Solanki

Abstract


For rehabilitation design processes, the new Mechanistic-Empirical Pavement Design approach relies heavily on the material stiffness, back calculated from the deflection measurements taken from existing pavements. These measurements are typically made using Falling Weight Deflectometer (FWD) or Heavy Weight Deflectometer (HWD) units. In order to provide high quality and consistent material stiffness data for the Mechanistic-Empirical Pavement Design the deflection results obtained at radial distance in between 0 and 1800 mm through geophone in FWD is highly useful. This review sought to examine the state-of-practice in FWD testing, analysis procedures and its research findings at national and international scenario. The deflection value obtained from FWD load application is directly used to estimate the structural and function condition of pavement is highlighted. Back calculation methods, correction to seasonal variations and calibration of FWD are not reviewed.


Full Text:

PDF

References


Srinivasa Kumar R. Pavement Evaluation & Maintenance Management System, Universities Press, 2014, 200–357p.

IRC: 81-1997 Guidelines for Strengthening of Flexible pavement using Bankelman Beam Deflection Technique. (1st Revision)”, Indian Roads Congress, New Delhi

Pandey B. B, Reddy K. S., Research Report on Structural Evaluation of Pavements in Eastern India using Falling Weight Deflectometer Road Research Scheme ( R-81), IIT Kharagpur 2003. It is published before IRC, same is available on IRC site.

IRC: 115-2014 Guidelines for Structural Evaluation of Flexible Road Pavement Using Falling Weight Deflectometer.

Carvalho, Régis L., Simplified Techniques for Evaluation and Interpretation of Pavement Deflections for Network-Level Analysis, McLean, VA: U.S. Dept. of Transportation, Publication Number: FHWA-HRT-12-023, December 2012.

Jia-Ruey Chang, et al. Evaluating the Structural Strength of Flexible Pavement using the Falling weight Deflectometer, Int J Pavement Eng 2002; 3(3): 131–141p.

Roque R., Ruth B.E., Sedwick S.C. Limitations of Back Calculation and Improved Methods for Pavement Layer Moduli Predictions. Proceedings of 5th International Conference on Bearing Capacity of Roads and Airfields, BCRA, 1998; 1: 409–417p.

Thompson M.R. ILLI-PAVE Based NDT Analysis Procedures. Nondestructive Testing of Pavements and Back Calculation of Moduli, ASTM STP 1026, Eds. Bush and Baladi, American Society for Testing Materials, Philadelphia, PA, 1989, 487–501p.

Molenaar A.A.A., Van Gurp Ch.A.P.M. A Pavement Management System for Provincial Roads in the Netherland. Proceedings of 5th International Conference on Structural Design of Asphalt Pavements, 1982; 1: 485–499p.

Wimsatt A.J. Direct Analysis Methods for Falling Weight Deflectometer Data. Transportation Research Record No. 1655, Transportation Research Board, Washington, DC, 1999, 135–144p.

Choubane R., McNamara R.L. A Practical Approach to Predicting Flexible Pavement Embankment Moduli using Falling Weight Deflectometer [FWD] Data. Research Report, FL/DOT/SMO/00-442, State of Florida, 2000.

Kumar R.S. Structural Evaluation of Pavements using Falling Weight Deflectometer. Ph. D Thesis, Indian Institute of Technology, Kharagpur, India, 2001.

Shell International Petroleum Company Limited, Shell Pavement Design Manual- Asphalt Pavements and Overlays for Road Traffic, Shell International Petroleum, London, 1978.

IRC: 37-2012 Tentative Guidelines for the Design of Flexible Pavements.

Badu K.T., Manzione C.W., Ruth B. E. et al. Prediction of Flexible Pavement Layer Moduli from Dynaflect and FWD Deflections. Nondestructive Testing of Pavements, ASTM STP 1026, Philadephia, PA 19103, 1989, 245–277p.

Heukelom W., Foster C.R. Dynamic Testing of Pavements. New York: American Society of Civil Engineers, J Soil Mechan Foundations Div 1960; 86, No. SM1: 1–28p.

Brown S.F., Tam W.S., Brunton J.M. Structural Evaluation and Overlay Design: Analysis and Implement. Proceedings of 6th International Conference on Structural Design of Asphalt Pavements, 1987, 1013–1028p.

Shook J.F., Finn F.N., Witczak M.W., et al. Thickness Design of Asphalt Pavements - The Asphalt Institute Method. Proceedings of 5th International Conference on Structural Design of Asphalt Pavements, The Netherlands, 1982; 1: 17–44p.

Edwards J. M., Valkering C. P. Structural Design of Asphalt Pavements for Heavy Aircraft, Koninklijke/Shell Laboratorium, Amsterdam, Holland, 1982.

Djunaedi Kosasih, Megi R. Sudiarto. The effects of pavement structure modeling and deflection Bowl analysis on calculated layer moduli. Journal of the Eastern Asia Society for Transportation Studies 2003; 5




DOI: https://doi.org/10.3759/ttea.v2i1.2796

Refbacks

  • There are currently no refbacks.